1.Material is Japanese cypress. I bought W250xt30xL2000mm four sheets, and the price was 8,000yen.

2.First, Making thickness is 25.5 mm by the surface planers.

3.Sanding by drum sander.

4.Make a corner right-angled.

5.The finished using the hand plane.

6.It is biscuit Joyner by MAKITA. I bought it one year ago.

7.A biscuit should put #20 into two piece.

8.Two sheets are pasted up.

9.Difference in rank is shaved by drum sander.

10.Pasting all board.

11.This is compass.

12.It is an easy structure of holding a mechanical pencil with a clip to square lumber.

13.The central part is using the nail.

14.Using band-saw for the cutoff to a round. Attach a jig.

15.It is a slider portion used for the central part of a circle.

16.Attach the slider of a jig to the center of a table on a screw.

17.Attach a slider to a jig. and unite the position which beginning cuts.

18.Attach a jig to a trimmer table.

19.Make a hook in stainless steel wire of 2mm.

20.Cutting an end-face of table on a curved surface by the trimmer. R of this bit is 52 mm in radius.

21.Central screw hole is filled up with an ebony, and a tree is carried out. Drilling 15-mm spot facing.

22.Next, make a leg. Material is a pine.

23.Making a right angle with a table saw.

24.Cutting a slanting line by band-saw.

25.Planing to the cut portion.

26.Cutting an front of a leg on a curved surface by the trimmer.Carry out a temporary assembly.

27.The material of a reinforcing board is the SPF.

28.Sprinkle water over the surface fully. Let's sanding after making it dry after that.I was pleased with the color of the Japanese cypress. But,My wife told me to do attach a color to table.

29.I chose the cherry color of watoco oil.

30.I think that it color is good touch.

31.It is completion when attaching a leg.

32.It is in the state which folded up the leg.

This table is heavy better than I had expected.