1.Material is a Cherry tree.

2.Cutting the work with the table saw.

3.Making a paper pattern.Template-1,Template-2

4.Writing the drawing on the cherry tree plate using a paper pattern.

5.The degree of angle of inclination of a jig is 5 degrees.

6.Centering of jig.

7.Positioning of drill.

8.Spot facing of diameter 30mm.

9.Penetration hole of 22mm.

10.Exchange the work stopper of a jig, from the right-angle plate to parallel plate.

11.5 degrees.

12.Using an L type stopper.

13.This is a model gauge for tenon.

14.Cutting.

15.Sanding.

16.Making the diameter 20mm of inlay.Material is a tree of a red sandalwood and a chestnut.

17.Stick a paper pattern on a work.Template-3

18.The first two inlays are only control by hand, without pasting up. Two inlays have a notch.

19.Pasting up inlays and drilling. The last two sheets should use inlay made first.

20.Drying.

21.Sanding.

22.Making a backrest.Template-4

23.Plane a board smooth.

24.Marking og heart shapes.

25.Hollowing a heart mark.

26.Cutting the outside of backrest with the band saw.

27.Sanding by a spindle sander.

28.Sanding by a disc sander.

29.Cutting square lumber into an octagon with the band saw.

30.Turning the support-stick for backrests.

31.Make tenon using a model gauge.

32.Wire burning.

33.Making a four legs.

34.Cut the slot on the wedge using a jig.This is jig with which a wedge slot is cut to round tenon of a leg.

35.Next, turn over and cut a leg deeply.It becomes 6 mm width.

36.Move a fence and carry out the 2nd cut.

37.Delete the portion which remained in the center of a slot by the band saw.

38.Cut off the tip of a leg at an angle of 5 degrees.

39.Sanding.

40.Hammering the wedge of a red sandalwood.

41.Delete the portion which jumped out using a dish bit.

42.Sanding.#400.

43.Fine tuning of height.

44.Preparation of a brand.

Finish by WATOCO oil.