1.The material is 7mmSUS circle sticks, 2mm aluminum plates and rosewoods, etc..

2.Cutting a 2mm aluminum plate.

3.Cutting a gum tree board and rosewood board.

4.This is the bracket installed in the aluminum plate.The center is a insert nut of M6.

5.M5 insert nut. This nut is for fixing of a bracket.

6.A scale board was made with beech wood. Write a scale line of 8 equal parts.

7.Cutting.

8.Make a scale line by a carving knife.

9.Assembly. The face side.

10. The back side.

11.Install a guide in the plunge base.

12.One scale is 0.125mm.