1.Before.

2.Completion of a stem. The material is a rosewood. I forgot to take a picture of the making process.

3.Making of a sheath. Put in the plywood jig which made steps of 3mm in one side of a rosewood. And dig a slanting ditch. The bit diameter is 30m/m.

4.Move a work with a jig, so a slanting ditch can be dug safely.

5.Gluing a board of symmetricalness by the yellow glue.

6.Make the band to suspend from hip. The material is leather of thickness 3mm.

7.Attach a band on a sheath.

8.Reverse side.

It was made a short time, I think it completed beautifully comparatively.

Stick 1 mm of neoprene rubber on the part which the cap hits.