1.The material is rubber tree.

2.First carve the ditch a T-slot rail enters.

3.Second, carve the ditch a measure enters.

4.Last,Carved in depth 5mm in its entirety.

5.Completion.

6.Make a collar. Pipe of the material SUS304.

7.Sanding the inside of the collar.

8.Put a nut with the nail and a collar in the works.

9.Make the hinge part which connects with the angle-bar.

10.Drilling 4mm to the L-30�~3 angle bar. and spot-face.

11.Tapping M4.

12.Drilling 6 4m/m to the hinge.

13.The slider. Glue together the aluminum material of 1mm at the SS material of 3mm.

14.Tapping M4.

15.Makes a support-pin with the cap screw of M4.

16.This is jig to make an acrylic cover.

17.Carve the hole using the template guide with 10 mm.

18.Cut a ditch in the pin with the metal handsaw.

19.Install an angle part in the table of band saw. Then,Drilling for a bolt and the dowel pin.

20.Install jig in band saw. and, Trning a jig. Cutting a ditch many times while tilting the table.

21.The hinge part.

22.Stik a measure tape. Then It is complete.

I thinks that it is easy to use in this jig.