1.The material is cypress and MDF.

2.Cutting the cypress for use in the fence.

3.Cutting the MDF.

4.Cutting the UHMW for use in the runner.

5.Drilling the MDF the hole for the runner mounting.

6.Put a runner to miter slot. and jointing the MDF and the runner with screws. Adjust to good slip condition.

7.The central parts of the fence.

8.Adhere the bottom and the upper parts.

9.Attach the fence to the MDF. Back side fence to fixed. Front side fence to loosely fix with one screw.

10.Stop just before the front side fence.

11.Adjust the front fence, a right angle to the blade.

12.Temporarily placed the blade cover. And check the position in which the blade does not come out.

13.Tapping M4.

14.Attach the stopper.The material is ss400.

15.Drilling for the blade cover mounting.

16.Put the cut to the blade cover. This is a safety cover.

It was complete.

Test cut.