1.First, I was to reinforce that overhang of vise with a piece of bubinga. The deflection of the plate passed away.

2.Second, I made an attachment-plate for sandwiching the works on the workbench. Make the material into an L�@by using a table saw.

3.First to put a cut of depth 5mm in the transverse direction, Then cut in the vertical direction.

4.To sink the head of the M6 cap screw. Spot facing of 15mm by forstner bit.

5.Drilling 7mm.

6.Tap drill hole 5mm.

7.Tap M6.

8.Mount a attachment-plate.

9.Attachment-plate is an L-shape.

10.Rugged!

11.I tried hold the works. The right side of the bench-dog board has become a slight lift. I decided to re-create this board.

12.Turning the legs of the board. Diameter is 15mm.

13.Join the legs to the board.

14.Good!