1.Data processed with Paint Shop Pro and Inkscape. Totoro's body is 1 mm pitch cross hatching, and the eye and number is a 0.2 mm pitch.

2.Material is MDF of 9 mm. Because it is 253 x 178 mm in size, lay it sideways. Set speed mm/min, output 100%, number of times 1.

3.The material of the needle is a 4 mm thick rose lwood.

4.Attach a clock hand.

5.The clock hands were inserted into a bamboo shaft with a diameter of 5 mm, and a cap covered with chestnut trees was put on the tip.

6.On the reverse side is stamping my brand mark. Diameter 60 mm.

My grandchild is playing happily with this toy.