Shelf storage of fret saw |
Apr. 14/2019 Fret saw frequently used recently. I always store it under the steel shelf. Then I use it by pulling it out on the work bench every time. It was heavy and the workbench space was also narrow, so we pulled it out of the steel shelf and made it usable. |
 |
 |
|
1.The base and guide were made of 18 mm thick plywood. To make space for fret saw legs at the tip, we are makeing the same slope as the legs on the plane. |
2.Adhere the 9 mm thick plywood as the lid. |
|
 |
 |
|
3.fret saw is pushed into the shelf. |
4.Pull out condition. |
|
 |
 |
|
5.Insert 2 * 4 on the front side. Then fret saw does not vibrate. Although it is not shown in the photograph, 24 is also contained on the back side of the shelf.It is fixed to the floor with two M6 anchor bolts. |
6.Since fret saw interferes partially on the shelf, So cut out a part of the shelf. |
|
 |
||
This is the state of work. I want you to watch a video in detail. |
||
 |
||
Stowed state. |
||