Baby Chair
Dec. 30/2007 Second,
I made the second. The 4th grandchild uses it.
The table diverted the last one.
I arranged the belt of the fall prevention.
Her name is Miwa. She is favorite in a new chair.
April 29/2002
I decided to make the chair which the height of the seat surface is changed into according to the growth of the grandchild.Also, I think that to use this chair is about 3 years probably.
After that, I attempted to think of the form as it is possible to put a garden plant bowl.
The material is cheap 2*4 and 1*4.
I writes an image with Paintshop and raises a heavy hip but I haven't started yet.
May 06/2002
I pictured a drawing based on the sketch.
I added a leg step and a table.
Drawing-1
){kind=link}
Drawing-2
){kind=link}
May 12/2002
First, I divide 2*4 material and I use it for the main pillar.It is possible to be straight cut when attaching a guide to the circular saw.
If four main pillars are made, I cut the tip in 22.5 degrees and 67.5 degrees.
A pillar with the same size is made when simultaneous with the slide-saw.
I join a pillar by dowel. Next, I score the position of the ditch.
In scoring, based on the perpendicular pillar, I write a line with the carpenter's square.
Then, it is possible to write a line correctly at the diagonal pillar, too.
I increasingly cut a ditch.
The tool uses trimmer M6 in Hitachi and the bit uses ø12*25L.
I put the bolt of M12 in the hole at the work stand.
Let's begin work after fixing a pillar surely.
This is important work.
The fixation causes the cut mistake and the injury when insufficient.
I don't cut corners even if I am troublesome.
I make a symmetrical pillar on either side.
If this is made, the after work is simple.
I fix a support for the back on the pillar in dowel.
Next, the elbow section, too, joins dowel.
Also, I will had better be driving in dowel for the table fixation beforehand.
2002/05/19
I manufacture the last part leg step and a table.
I manufactured a table by the 9mm plywood and the cryptomeria board of 40mm*12mm.
It's become the structure which the table doesn't reverse in dowel which threw oneself into the body.
When I take off the table I suspend a table from dowel from the reverse of the body.
I painted watoco oil only but the completing will seem fairly good.
The reconsideration point is the thing that the leg putting step was short a little.
I think that had better make about 50 mm long later.
Probably, I think that I reform it.
She don't use spoon yet.