I had an interest in fretwork.I made a design while I saw a photograph.
The material is beech.
First, I puts a sprayer paste to the back of the pattern in the wipe and I sets it to the face of material.
It's a rabbit.
Next, I cuts out along the pattern with the scrollsaw board.
This work is difficult.
I thought that it was important to think of the order to cut beforehand.
I make eyes with the drill and I peels off a pattern after cutting off.
I completes a section and an edge part lightly with the sandpaper.
Let's remove the paste which was left in the surface before sandinging.
Finshing is Planet-color.
