1.Supersize infeed and outfeed tables maximize work support.Compact and lightweight for easy transporting to the job-site.15 amp motor delivers no load speed of 8,500 rpm.Table size of 13 by 30-3/8 inches.Patented Interna-Lok automated head clamp minimizes snipe.

2.t made a stand with 200 mm height.To store a Workbench, this height is a limit.

3.I installed two fixation casters in the side. Tips 1.Wheel to touch a floor. 2.It is to chamfer a leg at the stand by about 10 mm.

4.I put the caster which can remove to opposite.It is the one to have made the wooden attachment of concavity and to have installed a free caster in the center.

5.When moving, I lifts a plane and it inserts the attachment of the caster in the stand.It moves lightly.

6.Next, it is dust collector. I bought the duct of the option but I have only a cleaner.I made reducer to connect with the cleaner with transparent PVC board with 1 mm thickness.

7.It is a test run.I shaved a cryptomeria board with 300 mm width.Because it was quite warping, I shaved a little while turning.

8.It was possible to have shaved beautifully.The parallel degree is OK.However, there is much waste.The cleaner is useless.I got to want a large-sized dust machine.

9.It fitted under the Workbench.

10.I picked up six rollers with 300 mm width. Next, it will make a roller stand using these.