1.This is an original table.

2.This is dual cylinder.I use this for the movement of the fence.

3.I enlarge the hole of the original table.It be possible to use a big Bit.

4.I cut off by the jigsaw.

5.I make a table with plywood.

6.I screw on the folder of Trimmer base in the reverse of the table.

7.I screwed on a cylinder and a fence.

8.This is screw for the movement.

9.This is dust collector hose and scaleI. The scale guide moves freely.

10.Trimmer is M6 by Hitachi Koki Co., Ltd.

11.T slot screw was used for the fixation of the fence. I carved the ditch by using the keyhole bit.

12.This miter gauge is shared with band saw.It completed.