Sharpening Jig for gouge |
Mar. 24/2007 This is jig that grinds bowl gouge and spindle gouge to the shape of the fingernail.Drawing |
 |
 |
|
1.I am making the part to support gouge. The Two-Jaw chuck attachment is useful. |
2.M8 tapping. The material is cherry. |
|
 |
 |
|
3.I use the diamond tool to process the board spring. |
4.I cut a length hole of the side plate by fret saw. |
|
 |
 |
|
5.This is the rod of jig. |
6.Each part were completed. |
|
 |
 |
|
7.Assembly. |
8.It attach a 13 mm bowl gouge. |
|
 |
 |
|
9.It attach a 10 mm bowl gouge. Using attachment. |
10.It attach a 6 mm bowl gouge. Using attachment. |
|
 |
 |
|
11.Next, I make jig for the grinder.These are the parts. |
12.I set jig in the grinder. |
|
 |
 |
|
13.I match the angle, roll jig right and left, and grind. |
14.It is convenient to mark the grinding position to the aluminum pipe. |
|
 |
 |
|
15.The jig and the attachment can be stored behind the grinder. |
16.If the aluminum pipe is extended, small gouge can be sharpening. |
|