1.I used a 70 mm pine for the frame.The bolt of M10.

2.I assemble a frame.

3.I inserted a plane in the bolt.It is possible to do a height adjustment on the W- nut.

4.It is an adjuster part.The right angle can be adjusted by pushing up the handle from the under.

5.This is a safe cover.I used 9 mm plywood.

6.I set an urethane sponge to the stopper of the safe cover.

7.The discharge mouth.A hose is connected with the cleaner.

8.I installed the table forward. Remodeling to the bench type is completed.

9.The table is the ash of 30 mm.

10.I made a ditch by the trimmer.It is a ditch into the miter gage.

11.I cuts the ditch of Feather board in band saw.

12.Feather board has a length hole.

13.I made a push block with junk material.It is 50 mm width and 85 mm.

14.This is hand SW. 100V,1500W

This Jointer is easy to use very much. And, it is possible to cut squarely.