1.The material is a gum tree. This is hard wood.

2.All parts.

3.Making the ditch in the nut.

4.Making the table which takes on a trimmer.

5.The length hole is cut with fret saw after drilling on both sides.

6.The slide bar is zelkova tree.

7.The slide part which carries a table.

8.Makes a square nut.The material is ss400 of flat bar 30�~6. first, M8 tap.

9.Cutting a flat bar.

10.Puts a square nut in the ditch and Holds it with the aluminum board of 1 mm.

11.Making the spacer of M8 volts.It glues together the circle stick of the zelkova tree inside and drilling a 8 mm hole.

12.Assembly of the spacer and bolt.

13.Drilling a 6 mm in the center of the washer.

14.Drilling a center hole in the bolt tip of M8�~150L.

15.Drilling a 3.3mm for the M4 tap.

16.Makes a spacer of Holding ring. Uses M8 nut for the backup of the washer. The M3 screw on the upper side becomes stopper of turn.

17.The table is turns 15 degrees.It used a M6 embed nut for the lock point.

18.Front of Holding ring

19.The completion.Next, use experimentally.

20.Fixes this jig on the Workbench. The table angle is 45 degrees.It uses a 90 degree bit.

21.Reversing a work piece, and it puts a ditch in X.

22.I introduces a way of using this work piece to the page of woodturning.