Clamps for drill press |
May. 22/2011 I made the Clamps for drill press. It is the jig which makes a hole, being right angle to the table.drawing |
 |
 |
|
1.Makeing a pivot. Cut the pin of 8m/m to the 22mm length. |
2.Drilling 4.2m/m. |
|
 |
 |
|
3.Tapping M4. |
4.The body of the clamp is a pine. Making to the ellipse-hole for the screw of M5 to swing. |
|
 |
 |
|
5.It assembled. |
6.I attempted to grasp 13 mm square pieces. Good!! |
|