Rotary drill chuck |
Jul. 08/2012 The rotational chuck is required when shaving a slender axis to a wood turning. I made because the commercial item was expensive. |
 |
 |
|
1.Convert chuck for impact drivers. The shank is a screw of W1/2. |
2.Extend the thread part of chuck with the drill of 13m/m. |
|
 |
 |
|
3.This is a collar which keep the space between bearings. It makes from pipe 6x7m/m of aluminum. |
4.A bearing is #686ZZ.The shaft is used for the rod of rod-less-cylinder.It is outside diameter 6m/m. |
|
 |
 |
|
5.Making a bearing stopper. Material is a washer of M8.Extend the Inside diameter with the drill of 9m/m. |
6.Drilling a 2.4m/m. |
|
 |
 |
|
7.Tapping a M3. It will be better to do the use of the spiral tap. |
8.Drilling a 2.4m/m to washer. |
|
 |
 |
|
9.The assembly was completed. |
10.It turns lightly. |
|