|
 |
|
 |
1.DR-400 arrived. It cannot have it alone. Because it is no less than 50 kg. |
|
2.First, assemble a steel stand. The mobile base for movement is put in under a stand. I attaches with a 900x720mm top plate, and carries Drum Sander on it. |
|
 |
|
 |
3.As for a mobile base, two of four flowers are fixation. I exchanged two wheels to the free caster. |
|
4.If casters are exchanged, the level cannot be maintained the lift rise side.Therefore, I inserted with 19mm thick square lumber under the stand by the side of a lift rise, and leveled. |
|
|
 |
|
 |
5.The dust-collecting port has become sideways. I think that the upper side is easy to use. |
|
6.The elbow was pasted up. I took pains to remove it. |
|
 |
|
 |
7.Instead, attach the reducer of PVC. An inside diameter is corrected with a lathe. |
|
8.Attach a reducer. |
|
 |
|
 |
9.The dust-collecting duct was inserted. |
|
10.Adjust inclination of a conveyor. The difference of a crevice shall be less than 0.2 mm. |
|
 |
|
 |
11.The scale showing an up-and-down position is an inch. |
|
12.I exchanged it to mm scale. |
|
 |
|
 |
13.I converted the steel shelf and stored Sander. |
|
14.I attached the surplus shelf board to the stand. |
|
|
 |
|
 |
15.A drum carries out about 0.4mm (1/64 inch) movement by handle 1/4 rotation. I attached the scale plate of a 0.1mm unit to the handle. |
|
16.I had a roller 3 mm in diameter, and 650 mm in length. I will make an out feed roller using it. |
|
|
|
 |
|
 |
17.A roller is narrower than the width of a stand. Therefore, a shaft is lengthened using a high nut 40 mm in length. |
|
18.It is complete. and comfortable because it is possible to fold. Please, mouse on a picture. |
|
 |
|
 |
19.Add one roller in the middle. |
|
20.The diameter of the roller is 21 mm. |
|
 |
I will use this drum sander effectively. |
|