| Circle-cut Jig-1 | Bearing-guide | Vibration | Dust-collector | Special-blade | Circle-cut Jig-2 | Flexible duct | feather board |

| Re Bearing-guide | Re Dust-collector | Extension table | Reinforcement of the table |

1.The material of the bracket.It is SS400 with 3 mm thickness.

2.Tapping M12.

3.Tapping M5. Center of original table.

4.Screwing a 3 t bracket on table.

5.A positioning pin is included in the hole in both sides of the bracket.

6.I made positioning pin with the bolt of M6.

7.Table size is 345�~900�~12mm.

8.Detail in the pin part.

9.It is possible to fold a table.

10.Detail in the hinge part.