1.The material is acacia. It bought it for the IKEDA MOKKOU in Hokkaidou.

2.I turn the whole for the bottom of the vase to come to the side of tailstock.

3.I cuts the ditch to grasp for Bantam chuck in the bottom beforehand. The circular shape can do chucking by being so.

4.It chuck the bottom of the vase in Bantam chuck. I thinks that to fix works on tailstock center surely is important.

5.Ring chuck can be substituted. I made this Ring chuck.

6.I makes a hole with the drill. It is rather un stable because it doesn't put Steadyrest. Steadyrest for long spindle turning or vases. Next, I will make Steadyrest.

7.I reduces the neighborhood of the hole by skew.

8.I polishes the inside of the use in Jig which wound a sandpaper around the circle stick.

9.Polish Jig cuts a circle stick with the handsaw, and it winds a sandpaper around it. It is convenient when preparing a various diameter jig.

10.The inside paints urethane and the outside is teak oil-finish.