1.I planed in the use Japan cedar in 2012NB of makita.

2.I glues together by Yellow glue.

3.I cuts out circularly in band saw.I was using a circle cut jig before but recently, I doesn't use it.

4.I installs a face plate with the screw.The screw at the center is jig for the center adjusting.

5.I turning the outside.

6.I exchange chuck and turn the inside.It is difficult to turn the Japan cedar.When cutting of cutlery is a little bad, do the hangnail of the surface. It is a problem when the future.

7.Lastly, I cuts off a hollow.It used "soft tail stock center".It can push a center softly.I made it.

8.I made two sheets of repeating and three sheets of repeating.This is the coloring completing of two sheets of repeating.A grain is beautifully.250mm Dia * 50mm Tall.

9.3 sheets. 250mm Dia * 50mm Tall.dark finish.

10.3 sheets.250mm Dia * 50mm Tall.clear finsh.I think that training is more necessary for the beautiful turning of the Japan cedar.

11.Feb. 11/2006
85mmDia * 25mmTall

12.Feb. 11/2006
140mmDia*40mmTall

13.Feb. 11/2006
280mmDia*70mmTall

14.Feb. 11/2006
280mmDia*70mmTall