1.First The center of the spoons width (not depth) is located and marked. The material is beech.45mm*27mm

2.It was gripped by drive center and tailstock.

3.I turn this outside in roughing gouge.

4.I used skew lastly. The handle has been sanded on the lathe. I only take the grit down to #220.

5.I install the disk Sanda jig in the lathe, and grind the bowl part.

6.I use a miniature router after it almost cuts it with the chisel and am as for the bowl.

7.I use Korean Perilla to finish.

8.Time hangs in the bowl making when it is a method of using the router. Therefore, I made the part of the ball a globular shape.

9.Next, I made jig that I chuck a bowl.I lightly with the tree hammer drum the part which becomes a bowl.

10.I pull out the inside in the hollowing.

11.I think that it can mass-produce the spoon by this method.

12.It is convenient with a globular gauge. I made with aluminum plate.

13.I made a sugar pot with the tree of the chestnut.

14.Top of pot becomes the handle of the spoon.