1.The material is beechen. Even here is easy.The process to here is easy.

2.The trimmer (Hitachi M6) is set in the self-made table.

3.The other side was fixed on the movement boss who removed tool rest.T bolt buries it under spacer.It is possible to move in the direction of Y freely.

4.The table can be fixed at an arbitrary angle by tightening the nut of T bolt.

5.The ditch of T bolt is seen from the side of spacer.

6.The trimmer is done back and forth and the amount of the incision is adjusted. The bit is 90 degrees.

7.This is an index board.I drilling 24 holes around the attachment face plate.It fix with the set bolt.

8.I shaved the six ones with the shallower angle first.Next, I change a table angle and I cut a ditch in the middle.I cut 12 ditches in amount.

9.The inlay is an isosceles triangle. The material is a red oak, Cri, a Japanesecypress, and ebony, etc.

10.I bond the inlay with the wood bond.

11.The pattern comes up when cutting down with gouge. I was affected when the pattern appeared.

12.It is finish.

I use Korean Perilla to finish.110mm Dia * 55mm Tall.