1.I screws a face plate on blank which was cut out in Band Saw.

2.I completes a outside roughly.

3.I marked with compass the circle which inserts ring.It's O.D 73mm.

4.I make spot-facing in the center with the drill. I don't have fosner-bit.

5.I was turning an indent for 73 mm diameter and 6mm depth.

6.I exchanges a face plate at four nails chuck. and puts an insertion ring in the indent.

7.I drilling in the center.

8.I turning the inside and outside. and polishings a surface. But,I doesn't polishing when It having lathe-line.

9.I made thin bowl, too.

It is completion penetrating WATCO oil twice.