1.The material is beech.I prepared four pieces of 30mm * 120mm length.

2.I put on a few white glues only the end.

3.I stop with the rubber band and I glue together four.

4.I puts it on the lathe it is.

5.I use roughing gouge and I scrape a center an elliptical form.

6.I take off here from the lathe and I take apart square lumber.When beating with the chisel, it is possible to break it simply.

7.I turn and I glue together two and I put a large-sized bell in.

8.This time, I glue them together perfectly.

9.The bell sticks out of the window.Therefore, I am turning after pushing time bubble urethane.

10.The timbre of the bell is good when rolling.

52m/mDia*90length. not painted.