1.The material is ebony, a rosewood, a Japanese oak.

2.I use a clamp and press, and I glue them together.

3.I squarely do the material by using bench type Jointer.

4.I glue together more again.

5.The material is supported at the drive center and the rotary center, and outer gets rough cut.

6.I used forstner bit of 25mm,35mm and 50mm.

7.Tturning the inside.

8.Inlaid.I fixed with the urethane tape after gluing inlay.

Oil finish.200mm Dia * 150mm Tall.