1.The material is a japanese oak,a cherry.The part of chuck.

2.The tail stock with round-center.

3.I turned by the skew.I mounted the cone cap to the tail stock.It's a hand-made.

4.This is a cone cap. It is supported by the spindle which has a needle bearing.

5.I polished the sole with the sand disk.

6.The axis has a 4 mm diameter.52mm Dia * 165mm Tall.Tang oil finish.The axis bends and like rubbery.

This is cherry wood.52mm Dia * 120mm Tall.Tang oil finish.The cherry wood is hard and It is easy to turning.