1.The material is a zelkova tree. uses roughing gouge and makes circular.

2.Open a pilot hall with the drill of 10m/m. Next, Cuts off the part which becomes a lid.The thickness is 6 mm.

3.Fortner bit was used for 35mm drilling. and Make Mate Fit in the edge.

4.Inserts a lid workpiece in Mate Fit and Turns it.

5.Turning out side.

6.Making a part of insert.

7.Turning the circle stick to use for the center axis of the box.

8.Making a knob and lid. Knob is rosewood.

It's Korean perilla oil finish.Please put mouse on the photo. The lid falls slowly.