1.The material is a cherry tree.It has a 30 mm diameter.At first, it is using the triangle bit of 60 degrees.Cutting a three ditches.

2.Next, changing with the straight bit of 6 mm. Pushing a bit into the center of the work.

3.The appearance of the twist rod.

4.Painted a classic color.

5.Making a pedestal.The material is a cherry tree. Using a screw chuck.

6.Turning an out side. Next, Drilling a 15 mm hole in center.

7.Gluing a temporary boss. It has ø15mm axis overhangs.

8.Turning a in side.

9.Cutting of boss.To stop Parting-tool in the axis position of ø15mm is important. Then, the work never flies.

10.Glue together a twist rod and a pedestal, and Painted a classic color.Next, making of the plate in the upper part.

11.The material is a red oak. Using a special screw chuck.

12.I mount a drill stand and it pricks a center.

13.Shift a center by 20 mm. DetailsEccentric Screw Chuck

14.When work is rotated by the arrangement, an eccentric circle is drawn. An eccentric circle is drawn while rotating the boss of screw chuck by 60 degrees.

15.Using button Joe.

16.Drilling 3mm.

17.Making the metal fittings which put in incense with the brass of 6mm. The hole is 2.8mm.

18.Insert a brass metal fittings in the center of the plate.

Completion. 260 mm height, 170 mm width of the seat, 87 mm diameter of the plate