1.The material is the circular cylinder to glue with the cherry tree and the Japanese oak each other.This hollow master is easy to use because the shank is a semicircle.

2.I made the jig to finish up the bottom of the vase flatly.

3.Insert the mouth of the vase in the jig. Then,push�@the bottom of the vase with the soft tail stock and turning it.

4.The vase entrance is made the zigzag by the bit by 60 degrees.

5.I retook it later because I had forgotten the photograph of centering. When vacuum chuck is used, works is adjusted with the dial gauge.

6.The lid is made from the Bombay black wood.

7.Paper that marks the tear off along dotted line is put on the lid with the spray glue.

8.Cutting it with the jigsaw.

9.Hole 5m/m to insert knob.

10.The material of the knob is bonded to the lid.And, turning of the lid.

11.Making of knob.

12.Knob.

Completion. 85mm height, 105mm diameter. Oil finish.