1.Cutting a rosewood in the 6.2 mm cubic on band saw.

2.Sanding by self-made 300mm disk Sander.

3.Cutting a chestnut of 6 mm thickness to 12 mm width by band saw.

4.Gluing a rosewood and chestnut.

5.Sanding a gluing surface if dry.Gluing the next chestnut board.

6.Gluing four pieces.Holding it to clamp have not to be cracking.

7.Make square with the plane.

8.Completion of inlay part.

9.The outside is a chestnut , inside is ebony.

10.Using a drive center and a turn center. Turning the side of the tail stock.

11.Next,turn to the 15 mm diameter.

12.Making a bowl. The material is a cherry tree. Opening a pilot hall.

13.Setting a drill stand, and drilling 12 of 15 mm with forstner bit.

14.cut inlay with band saw.

15.glue together.

16.Oh my god!! I had cut off a work by mistake.

17.I tried a recover. Then, it was restored.

18.Using a vacuum chuck, and turn a bottom of bowl.

Urethane finish.165mm diameter 52mm height. Next time, I will beware when turning.