1.Polish the nail of the same thickness as the braid of the table saw.

2.Make a tip circular.

3.Make parts for the miter fence of table saw. The 2in*4in material is processed to the rectangular lumber of 60mm*35mm*580mm, and the ditch of 3mm in depth is cut.

4.Gluing a nail.

5.Make louver.The material is 14mm*32mm*604mm of the chestnut. The louver disk of 190mm in the inside diameter should be able to be made from this. Hold work to the nail of positioning first. And, cut the first ditch.

6.Ditch since the second. Insert a previous ditch in the nail completely.The ditch of equal intervals cuts if it does so.

7.When all ditches are cut, a huge comb board is completed.

8.Putting a partial packing tape of the belly of the comb.

9.Cutting an unnecessary gummed tape.

10.Cutting the comb side of the back by band saw.

11.The comb winding when cutting.

12.It sees it like the flower when work is rolled on the disk of 192mm.

13.Make the board pasted to both sides of the louver disk. The material is ebony.

14.Bond parts to become a semicircle.

15.Make the part of semicircle "line" a straight line with a disk sander.

16.Bond the semicircle mutually. It becomes 12 equiangular.

17.The ebony board is bonded to the louver. Let's work carefully.

18.When ebony can be bonded to both sides, the packing tape is peeled off.

19.Cut the circle outer by bandsaw.

20.Tighten outer of the work in the hose band. And turning the side.

21.The bowl is made from the zelkova. Let's use S tool rest.

22.Bond the slat to the bowl.

23.Turning of outer. Turning after pushing the center of the bowl.

24.Inside turning. Because hardness is different, the turning is difficult.

25.Grip the bowl by vacuum chuck.

26.And, cut the grip part of the bottom.

100mm height, 216mm diameter. Beeswax finish.