1.Making a spin-top.The shank is 7.9 mm diameter.

2.Making a holder of spin-top.

3.The left part is grip, a top is into the left part.

4.Wire burning.

5.Cutting.

6.Drilling a 8mm.

7.Drilling a 20mm.

8.Making the handle which pulls a string.

9.Drilling a 2mm to shank of spin-top.

10.Drilling a 2mm to shank of handle. and spot face 3.5mm.

This spin-top is high-speed and spins long.

Making the table which turns a spin-top by the addition.The material is a camphor tree.

50mm height, 220mm diameter. Beeswax finish.