Works of wood turning [Page58] |
Lathe & Tool | |
Jun. 17/2012 The little tray from branch. I made the little tray from branch. This is the same as an angel's wing which I made before. |
 |
 |
|
1.Fix using Screw chuck. A drill hole is 6.5 mm. |
2.The whole is turning ellipse and a grip end is made. |
|
 |
||
3.Reholding by Bantam chuck, and turning an inner side. |
||
 |
||
I think that the tray was somewhat too large.It is larger than a glass. |
||