1.The material the of handle is chestnut and the zelkova. and Steel is HSS.

2.Turning to the circle stick of 30mm.

3.The part by which put on cap of brass. Put the steps of 26m/m.

4.Turning according to the cap.

5.I copied a handle to Robert sorby.

6.Drilling a 1/2 inch.

7.Pasteing the steel materials and a cap on a handle by an epoxy glue.

8.Replace with a three nail scroll chuck. and hold a steel-materials part.

9.Wire burning.

10.Rivet into wooden grip.

It finished by urethane. I would like to operate a steel portion according to a future use.
The full length is 420 mm.