1.The material is a cherry tree, ebony, rosewood. Cutting it in the 6mm thickness by band saw.

2.Sanding it in a thickness to 5mm by dram-sander. The dram-sander is a convenient power tool.

3.Cutting it in the 60mm width by table-saw.

4.The board is one set at four sheets. They are for seven pendant.

5.Making a waste board. Cutting it in the 100mm*60mm*15mm by band-saw.

6.Gluing together things for two sets at once. Don't glue the center.

7.Remove Joe of chuck by two sheets, and chucking waste board diagonally.

8.Turn it using bowl gouge.

9.Turning the waste board slender by using parting tool.

10.Grasp waste board once more on shift. and, make a hole which lets through a string.

11.The beeswax finish. The right is 50mm at the 30mm diameter in the left.

12.Make a striped board with the remaining board.

13.Sanding it by dram-sander.

14.I drew the image figure about the position into which a striped board is put.

15.How do you think about this?.

16.This is the leather to have gotten from the friend. I think that I will make a string with this.

What do you think about this pendant? .Pretty?