Works of wood turning [Page76] |
||
1.The material is pine. |
2.Make a jig for the hemisphere hole.The material is aluminum. |
|
3.Exchange to the two-Jaw chuck. |
4.Drilling 25.4mm by forstner bit. and turning. |
|
5.Repetition of this work. |
6.Glue together. |
|
7.Make a jig to dig a rectangle groove.drawingof jig. |
8.Cutting. |
|
Digging completion. |
10.Drilling to put the neodymium magnet. |
|
11.Paint the WATOCO oil. and, take dried a few days. |
12.Bonding a neodymium magnet to the board. |
|
Be the first to start a mancala party! |
||