1.The material is beech in the 26 mm square lumber.It uses a drive center and a turn center.

2.I turns the part which becomes the head of the spoon to the 24.5 mm globular.It should use the gage of aluminum.

3.The axis is made by the skew like the taper.

4.I drum the head of the spoon into jig.Next, it hollows the inside with bowl-gouge.

5.I made a piercing hole of 6 mm in the center of jig. The hole is to take out a work. I sticks a spoon out of jig.

6.finish.