| Introduction | Mount of a trimmer | Adjuster | Throat plate,Riving knife | clamp and dust collect port and blade |

| Out feed roller | Mount of a PORTER-CABLE 893 router | Dust collector for 893 router | Remodel the router fence |

| Miter slot-bar | Cross cut Jig | Ripping Jig | Anti-Kickback Safety Rollers | Insert ring |

1.The diameter of a roller is 38mm and length is 600mm.

2.Other parts are a shelf support and a light angle of 40 mm.

3.Exchange a bearing. #6202zz.

4.Cutting an angle part.

5.Angles interfere with the frame of a table saw. Cutting aslant.

6.Fitting an angle in the frame with the tapping screw.

7.Cutting a roller in 50‡o.

8.Cutting a shaft by 50 mm. I shaved a little of the use wt-300.

9.Making a screw with M10 die.

10.Making the board to put between the shelf support and the roller.

It is complete. and comfortable because it is possible to fold. Please, mouse on a picture.