Table-saw Ryobi BT3100 Remodel-1
| Introduction | Mount of a trimmer | Adjuster | Throat plate,Riving knife | clamp and dust collect port and blade |
| Out feed roller | Mount of a PORTER-CABLE 893 router | Dust collector for 893 router | Remodel the router fence |
| Miter slot-bar | Cross cut Jig | Ripping Jig | Anti-Kickback Safety Rollers | Insert ring |
Feb. 14/2010
Introduction
I got table saw from the my friend.
It is secondhand BT3100 RYOBI-USA. but it is beautiful.
I will remodel it.


Caster
First, I set a free caster to four legs.
The movement became easy.


Scale
I exchanged scale from the inch to the millimeter.


Feb. 2010/28
Mount of a trimmer
1.The material is 17S of duralumin. Cutting in the hole with jigsaw.
2.Drilling and tapping. M6.
3.Imbeds a magnet's. It is powerful neodium.
4.This is one one dollar at 10.
5.Mounting the base of the trimmer to table.
6.I make a crack plate with chopping board.The material is polypropylene.
7.Turning. PP is easy to turning.
8.Drilling@4.8mm@for neodium.
9.Pushing a magnet by the vise.
10.Drilling. ø10mm,15mm,25mm,35mm.
11.This is dust collector port.
12.It is possible to remove with single touch.
13.The joining of the rip fence and a trimmer fence.
14.The guide of the extension table. The side of front rail.The material of the guide is a rosewood.
15.The guide of the extension table.The side of rear rail.
16.This miter gauge is shared with band saw.
[Home]