| Introduction | Mount of a trimmer | Adjuster | Throat plate,Riving knife | clamp and dust collect port and blade |

| Out feed roller | Mount of a PORTER-CABLE 893 router | Dust collector for 893 router | Remodel the router fence |

| Miter slot-bar | Cross cut Jig | Ripping Jig | Anti-Kickback Safety Rollers | Insert ring |

1.This fence was bought for 20 ago.

2.A fence of the left and right moves independently. First,Dig the ditch a T-slot bar enters.

3.Make a slot-rail for the stopper and the feather board.

4.Install the T-slot bar.

5.Completion.

6.A fence loosen a 2 knobs in the back, and moves.

7.Stopper for works.Drawing

8.How to use.

9.Feather board.Drawing.

10.How to use.

11.Hollow out in the form of a groove for the feather board.

12.How to use.

13.The offset spacer when shaving all end faces of a work. Made of aluminum. The thickness is 0.5mm and 1mm.

14.Put a spacer in the left side fence.

15.Making a starting-pin. This is ss400 steel of diameter 12mm.

16.How to use.